bebeduE MAGIC Manual Del Usuario página 50

UK
HOW TO ADJUST THE TRANSPORT HANDLE (Fig.3)
Press the red buttons on both sides and move the transport handle to the desired position.
It has 5 positions.
HOW TO FASTEN GROUP 0+'S SAFETY BUCKLE-CLASP (Fig.4)
A. Fit both parts of the buckle's connectors.
B. Fit the two connectors of the buckle in the slot located on the upper part of the buckle.
C. Always check that the harness is correctly buckled by pulling on the shoulder straps upwards.
D. To unbuckle the harness, press the red button on the buckle.
HOW TO ADJUST THE HARNESS
Lift the shoulder straps to tighten the waist harness and then pull on the adapter strap until
the harness is completely tight (Fig. 5).
You must adjust the harness to its maximum in order to avoid the child from feeling
uncomfortable.
Make sure the waist strap on the harness remains under the child's tummy, as close as
possible to the thighs. A loose harness may be a hazard. Check that the harness adequately
adjusts and tighten it whenever the child is in the chair.
To loosen the harness, push down on the "Press" mark while holding the two shoulder straps
with the other hand. Push the shoulder straps towards yourself to loosen the harness (Fig.6).
ADEQUATE HEIGHT FOR THE SHOULDER STRAPS (Fig. 7)
The harness has two height positions.
Always check that the shoulder straps are at the right height for the child. The child's shoulders
must always be below the slot of the harness.
CHANGING THE HEIGHT OF THE SHOULDER STRAPS (Fig.8)
A. Unbuckle the harness by pressing on the red button.
B. Remove the protectors from the shoulder straps.
C. Remove the reducer.
D. Pull on the straps from the rear part of the backrest and pass them through the next upper
or inferior position slot.
E. Once you have passed the straps through the desired slot, replace the reducer and strap
protectors.
STEPS PRIOR TO INSTALLATION
This carrycot can "only" be installed in the Bebédue pushchair.
First open the stroller and put the brake on the rear wheels.
Lining and place the backrest in a stretched-out position.
Unfasten the clips located on the bottom part of the armrest, this with the aim of leaving the
stroller's anchor devices in view and to facilitate installation (Fig. 9).