Downloading Further Instructions - Balluff BML-S2C0-Q Serie Manual Del Usuario

BML-S2C0-Q _ _ _ -M6 _ _ - _ 0-KA _ _ /KF _ _ /KA _ _-S284
Incremental Magnetic Linear Encoder
EU Directive 2004/108/EG (EMC Directive) and EMC law
Noise immunity: EN 61000-6-1/EN 61000-6-2
Emission: EN 61000-6-3/EN 61000-6-4
Intended use
The BML magnetic linear encoder is intended for
communication with a machine control (e.g. PLC). It is
intended to be installed into a machine or system. Flawless
function in accordance with the specifications in the
technical data is ensured only when using original
BALLUFF accessories. Use of any other components will
void the warranty. Non-approved use is not permitted and
will result in the loss of warranty and liability claims against
the manufacturer.

Downloading further instructions

A complete standard user's guide can be downloaded
from the Internet at www.balluff.com/downloads-bml
or requested via e-mail from service@balluff.de.
Installation and connection
Linear and rotative applications:
X
20
Z
Forwards direction of travel,
A before B
Free area of magnetizable material
Connection type: ...-KA_ _-S284
~49
www.balluff.com
+Yaw
–Yaw
–Roll +Roll
Y
–Pitch
5
5
+Pitch
Cable length
Start of magnetic tape
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the linear encoder will
not result in hazards to persons or equipment.
If defects and unresolvable faults occur in the linear
encoder, take it out of service and secure against
unauthorized use.
Working range
Accuracy class 1)
Z 2)
1 to 5 mm
(sensor/magnetic tape (with cover strip
gap) max. 4.85 mm)
Y Max. ±2 mm
(side offset)
X
Yaw
Pitch
Roll
1) System accuracy:
Accuracy class I ±400 µm (working range)
Accuracy class II typ. ±550 µm (function range)
2) A gap of 3 mm is recommended.
Connection type: cable
2.5
17 4
Ø3.5
Ø6
35
BML-M...-I6_-... magnetic tape
(not included in the scope of delivery)
Left
Rear Front
Right
File no.
E227256
Distances/angles
Function range
I II
0 to 6.5 mm
Max. ±4 mm
max. ±0.5 mm
< ±3°
< ±1°
< ±3°
10
Active measuring surface
End of magnetic tape
english 1