Read First; Safety Information - Ideal Split-Jaw Smart-Meter Manual De Instrucciones

Warning Safety sheet
. . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . .
. . . . . . . .
. . . . . . . . .

Read First

Safety Information

To ensure safe operation and
service of the Tester, follow these
instructions. Failure to observe
warnings can result in severe
injury or death.
- Avoid working alone so assistance
can be rendered.
- Do not use test leads or the Tester
if they look damaged.
- Do not use the Tester if the Tester
is not operating properly or if it is
wet.
- Use the Tester only as specified in
the Instruction card or the protection
by the Tester might be impaired.
- Use extreme caution when working
around bare conductors or bus bar.
Contact with the conductor could
result in electric shock.
- Do not use the Tester to measure
voltages in circuits that could be
damaged by the Tester's low input
impedance (approximately 4KΩ)
- Use caution with voltages above
30 V ac rms, or 60 V dc. These
voltages pose a shock hazard.
Symbols as marked on the
Tester and Instruction card
Risk of electric shock
See instruction card
DC measurement
Equipment protected by dou-
ble or reinforced insulation

Battery
Earth
AC measurement
Conforms to EU directives
2