GreenWorks ST40L210 El Manual Del Propietario página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
GRASS DEFLECTOR
INSTALLING AN ATTACHMENT TO THE POWER HEAD(See Figure 3.)
W A R N I N G
Read and understand entire Operator's Manual for each optional attachment used on this power
head and follow all warnings and instructions. Failure to follow all instructions may result in
W A R N I N G
Never install, remove, or adjust any attachment while power head is running. Failure to stop the
motor can cause serious personal injury. Never operate power head without an attachment.
NOTE: When using string trimmer attachments, use only .080 in. diameter line.
The attachment connects to the power head by means of a coupler device.
Loosen the knob on the coupler and remove the hanger cap from the attachment.
Push in the button located on the attachment shaft. Align the button with the guide recess on
the power head coupler and slide the two shafts together. Rotate the attachment shaft until the
button locks into the positioning hole.
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked
into place. Slightly rotate from side to side until the button is locked into place.
Tighten the knob securely.
SLOT
ATTACHMENT SHAFT
10
POWER
HEAD SHAFT
KNOB
Fig.2
Fig.3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2100702

Tabla de contenido