Invacare 6270E Instrucciones De Montaje, Instalación Y Funcionamiento página 2

DESCRIPTION
Wheeled Walker Accessories make a standard pick-up walker easier to use for people that find
it difficult to lift or maneuver a standard walker and will allow the user to walk more naturally
and with greater ease.
To use the walker with the wheel attachments, push the walker forward as you walk. The
walker will move with you.
INSTALLING FIXED WHEEL ATTACHMENTS MODEL NO.
6270E (FIGURE 1)
NOTE: Refer to the INSTALLATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1. Remove two (2) existing front leg extensions from walker by depressing the snap buttons.
NOTE: Front leg extensions will not be re-assembled to walker when using wheel attachments.
2. Depress snap button on walker legs and slide wheel attachment onto two (2) front legs of
walker.
NOTE: When using fixed wheel attachments, wheels should be positioned on outside of walker.
3. Adjust each wheel attachment. Ensure that the snap button of each leg fully protrudes
through the desired adjustment hole and legs are adjusted so the walker is level.
4. Remove rear rubber tips and replace with glide tips. Glide tips will fit inside the leg
extensions and may need to be tapped into place with mallet or hammer.
FIGURE 1 - INSTALLING FIXED WHEEL ATTACHMENTS MODEL NO.
WHEELED WALKER ACCESSORIES
Rear
Front
Snap
Button
6
9
Fixed Wheel
Attachment
ITEM DESCRIPTION
1. Anti-Rattle
2. Adjustable Leg 10-inches
3. Screw, Hex 1/4-20 x 2-1/2-inch
4. Wheel-3-inch
5. Bushing 3-inch Wheel
6. Locknut (1/4-20)
7. Washer
8. Bushing
9. Glide Tip
*Quantities are per component.
6270E
1
2
7
4
5
7
8
QUANTITY
1
1
1
1
1
1
1
1
1
2
3
Part No. 1061349