Candy CVBN 6184WBF/S1 Manual De Instrucciones página 21

3. Disassembly of water valve components
Use the (screwdriver), and its tool edge shall be in alignment with and inserted in the vacancy
at the skirt border, which is bulged at the top of water valve components, then rotate the
screwdriver clockwise or anticlockwise, after the rotation, use the tool bit to open the water
valve and then pull out the water valve components in the direction of 45° of oblique upward
by hands.
Attentions:
Make sure that the water tank is empty before moving it.
1. The water valve components are non-detachable;
II.
Cleaning
1. To disassemble the water tank, water tank cover, sealing ring and water valve;
2. Use cold or warm water to cleaning the components of water dispenser.
3. Wipe it with dry cloth.
Attentions:
1. If the cleaning solution is used for cleaning water dispenser, then it is suggested
that, before the water taking and drinking, the water shall be drained to the amount
of 5-6 cups after the water tank is installed back, so as to avoid the residue cleaning
solution.
III.
Installation
1. Installation of water valve components
The guiding boss on the water valve components shall be in alignment with the guiding slot on
the base, and press it down in the direction of in the direction of 45°of oblique downward by
hands with strength, until you may hear the sound of "lick".
2. Installation of water tank sealing ring
To install the sealing ring on the bottom of water tank by hand, make sure that it is properly
installed, and the wrinkling and oblique installation and so on shall be avoided.
23