Safety Precautions; Setup Instructions - OTC 5213 Manual De Instrucciones De Operación Y Lista De Partes

Parts List & Operating Instructions
Item
No. Qty.
No. 531127 Seal Kit includes:
10
16
18
No. 531128 Handle Kit includes:
WARNING: To prevent personal injury and damage to equipment,
• Study, understand, and follow all instructions and safety precautions.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Use the jack on a hard, level surface.
• Inspect the jack before each use; do not use the jack if it's damaged, altered, or in poor condition.
Use only OTC approved parts on the jack.
• Use the jack for lifting purposes only. This jack is designed to LIFT loads, not support loads.
Immediately support a lifted load with appropriate means.
• Never exceed the rated lifting capacity of the jack.
• Center the load on the jack saddle. Off-center loads can damage seals and cause jack failure.
• Lift only dead weight. Do not move the jack while it is supporting a load.
• Stay clear of lifted loads.
• Use only attachments and/or adapters supplied by the manufacturer.
• Lower the jack slowly and carefully while watching the position of the jack saddle.
• Use only approved hydraulic fluid (type HL or HM).
This guide cannot cover every situation, so always do the job with safety first.
Before operating the jack, purge the hydraulic unit to elimate any possible air in the system.
Bleeding air from the system:
1. Purge the system by opening the release valve; use the handle to turn the release valve 180° counterclockwise.
2. With the jack in an upright position, place the handle into the handle socket, and pump the handle rapidly several
times.
3. Close the release valve by turning it clockwise until tight, and pump the ram to its full height.
4. Open the release valve, and let the ram descend quickly. Repeat if necessary.
1. Unscrew the extension screw until the saddle is close to the load.
2. To raise the jack, close the release valve by turning it clockwise. Insert
the handle into the pump receiver and operate the pump.
3. To lower the jack, slowly open the release valve knob by turning it
counterclockwise.
Using the jack in a horizontal position: Place the jack on its side so the
pump is lower than the reservoir as shown.
Replacement Kits for the 5213 Hydraulic Jack
Description
1 1 Ring
3 1 O-ring
5 1 O-ring
6 1 Ring
1 O-ring
1 Seal
1 Filler Plug
7 1 Handle

Safety Precautions

Setup Instructions

Operating Instructions
Form No. 530685, Sheet 1 of 2, Back
Item
No. Qty. Description
No. 531129 Hardware Kit includes:
2 2 Ring
9 1 Release
11 1 Ball
12 1 Ball
13 1 Axle
14 1 Retaining Ring
15 1 Spring
17 1 Handle Socket
19 1 Ball
20 1 Safety Valve
21 1 Washer
Release
Valve
Reservoir
Pump