Pairing of handsets
The handset supplied with the base unit is already paired.
You don't need to re-register them, unless you have a problem.
Maximum 5 handsets can be registered to the same base unit and
maximum 4 bases per handset.
Firstly, be sure the base is connected to mains power and the handset is
close to it (300m outside and 50 inside). If the handset is already
registered, the display will show its number and strength of signal with
the base. If not, you need to re-register the handset again using the
following process:
NOTE: You need to operate the base and handset together
•
On the base, press MENU key.
•
Press ▲ or ▼ to select REGISTRATION submenu.
•
Press MENU to enter. Display shows SEARCHING and it flashes.
•
At the same time, press OK key on the handset to see
PHONEBOOK
•
Press ∧ or ∨ key to select REGISTRATION
•
Press OK to see BASE 1 (If the handset already has a registration
to a base there is a "+" on the right side of the display, and you
should choose another base number if you don't want to lose it).
•
Press OK to confirm. The display shows PIN?, Enter PIN code for
the base (0000 by default).
•
Press OK to confirm
Answering Machine (TAM)
The answering machine can record messages from incoming callers or
memos directly at the base. Each message or memo can be up to 2
minutes long, and the total recording time available for all
messages/memos is about 60 minutes.
Press MENU key, then press ▲/CID or ▼/OUT key to select TAM. Then press
MENU key to confirm and enter.
MESSAGE
You need to enter PIN code to restore settings.
The call log will be cleared but Phonebook will
not be changed.
Press again MENU to enter and to listen to
messages. Press
key to pause the message play.
15