Publicidad
Important: Changes in the settings marked with
for the Selectrix mode of operation automatically
lead to changes in the DCC mode of operation
and vice versa!
Other changes are not possible. The values set at
the factory have been selected to insure trouble-free
operation.
Settings for different parameters:
CV
1
3
4
5
*
10
17
18
30
Description
Address
Acceleration delay
Braking delay
Maximum speed
Motor Control
CV10 = 0 Motor EMF-controlled
CV10 = 1 Motor not controlled
Extended address (Upper part)
Extended address (Lower part)
*
Both powered end cars must always be functionally
connected to one another on the programming track
in order to program the train properly.
The operating instructions for your central unit
(example: Central-Control 2000) will give you exact
procedures for setting the different parameters.
With many systems the values set at the factory
can be read in the programming mode.
DCC Value
1 – 99
0 – 127
0 – 127
1 –
0, 1
CV 29 Bit 5 = 1
CV 29 Bit 5 = 1
Selectrix Value
1 – 99
1 – 7
1 – 7
7
1 – 7
Not necessary
Not necessary
Not necessary
Publicidad
