Panasonic SC-PT770 Instrucciones De Funcionamiento página 14

Setting up the radio (continued)
Numbered
buttons
OK
14
1 2 3
4 5 6
7 8 9
0 10
SKIP SKIP
,
OK
SELECTOR TUNE
Presetting stations manually
Up to 30 stations can be set in each band, FM and AM.
1 While listening to the radio broadcast
Press [OK].
2 While the frequency is flashing on the display
Press the numbered buttons to select a channel.
≥ To select a 2-digit number
e.g. 12: [S10]
Alternatively, press [X, W], and then press [OK].
Main unit:
1 While listening to the radio broadcast
Press [MEMORY] twice.
2 While a channel number is flashing on the display
Press [X TUNE W], and then press [MEMORY].
A station previously stored is overwritten when another station is stored in
the same channel preset.
FM frequency step
Main unit only
The step is factory-set to 0.2-MHz, but you can change it to receive
broadcasts allocated in 0.1-MHz steps. You may need to change this
setting if the tuner seems to skip over the correct frequency for stations in
your area.
1 Press [SELECTOR] to select "FM".
2 Press and hold [SELECTOR].
MEMORY
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
VOLUME
changes and the step is changed.
e.g. 87.9 (Factory preset) ,# 87.5
To return to the original step, repeat steps 1 and 2.
[Note]
After changing the setting, previously preset frequencies will be cleared.
Preset them again.
[1] [2]