Trix Re 4/4 I Serie Manual De Instrucciones página 6

Function
• Built-in electronic circuit for operation with a conventio-
nal DC power pack (max. ±12 volts), Trix Systems, Trix
Selectrix or NMRA DCC digital systems.
• Automatic system recognition between digital and
analog operation.
• No automatic system recognition between Selectrix (SX)
and DCC.
• Headlights for the locomotive change over with the
direction of travel. They can be turned on and off in
digital operation.
Notes on operation with direct current
• A filtered direct voltage is required for operation.Ope-
rating systems with pulse duration control are therefore
unsuitable.
Notes on digital operation:
• This locomotive comes from the factory programmed
for the digital address "01" (Selectrix) / "03" (DCC).
Number of speed levels that have been set: 28 (DCC)
and 31 (Selectrix).
• The first time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this digi-
tal system. To do this, the decoder must be program-
med once in this digital system.
• Information about DCC Operation:
The setting done at the factory does not permit opera-
tion with opposite polarity DC power in the braking
block. If you want this characteristic, you must do with-
out conventional DC power operation (CV29 / Bit 2 = 0).
• Controllable Functions:
– f0: Direction-dependent Headlights
– f3: Locomotive whistle
6
The operating instructions for your central unit (example:
Mobile Station) will give you exact procedures for setting
the different parameters. With many systems the values
set at the factory can be read in the programming mode.
Safety Information
• This locomotive is only to be used with the operating
system it is designed for.
• This locomotive must not be supplied with power simul-
taneously by more than one power source.
• Please make note of the safety information in the
instructions for your operating system.
The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for
this purpose. The interference suppression set is not
suitable for digital operation.
No warranty or damage claims shall be accepted in those cases
where parts neither manufactured nor approved by Trix have
been installed in Trix products or where Trix products have been
converted in such a way that the non-Trix parts or the conversion
were causal to the defects and / or damage arising. The burden
of presenting evidence and the burden of proof thereof, that the
installation of non-Trix parts or the conversion in or of Trix products
was not causal to the defects and / or damage arising, is borne by
the person and/or company responsible for the installation and / or
conversion, or by the customer.