Safety Notes; General Notes; Function; Notes On Digital Operation - Trix 23 Serie Manual De Instrucciones

Safety Notes

• This locomotive is only to be used with the operating system
it is designed for.
• Use only switched mode power supply units and transformers
that are designed for your local power system.
• This locomotive must not be supplied with power from more
than one power pack.
• Please make note of the safety notes in the instructions for
your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.

General Notes

• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well as
transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• http://www.maerklin.com/en/imprint.html
Functions
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix
or NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between Selectrix (SX) and
DCC.
• The full range of functions is only available under Trix Sys-
tems and under DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
• Minimum radius for operation is 360 mm / 14-3/16".
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.

Notes on digital operation

• The first time the locomotive is used in a digital system (Selec-
trix or DCC), the decoder must be set for this digital system. To
do this, the decoder must be programmed once in this digital
system (Example: changing an address).
• The operating instructions for your central unit will give you
exact procedures for setting the different parameters.
9