Descargar Imprimir esta página

Trix RAm Serie Manual De Instrucciones página 9

Ocultar thumbs Ver también para RAm Serie:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Function
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix or
NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between Selectrix (SX) and
DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
Notes on digital operation:
• This locomotive comes from the factory programmed for the
digital address "01" (Selectrix) / "03" (DCC). Number of speed
levels that have been set: 28 (DCC) and 31 (Selectrix).
• The fi rst time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed once in
this digital system.
• Information about DCC Operation:
The setting done at the factory does not permit operation with
opposite polarity DC power in the braking block. If you want
this characteristic, you must do without conventional DC power
operation (CV29 / Bit 2 = 0).
The operating instructions for your central unit (example: Mobile
Station) will give you exact procedures for setting the different
parameters. With many systems the values set at the factory can
be read in the programming mode.
Safety Information
• This locomotive is only to be used with the operating system
it is designed for.
• This locomotive must not be supplied with power simultane-
ously by more than one power source.
• Please make note of the safety information in the instructions
for your operating system.
The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interference
suppression set is not suitable for digital operation.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
WARNING! This product contains magnets. Swallowing more
This product contains magnets. Swallowing more
This product contains magnets. Swallowing more
!
!
!
!
!
!
!
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
than one magnet may cause death in certain circumstances.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
If necessary, see a doctor immediately.
9

Publicidad

loading

Este manual también es adecuado para:

22131