Brinkmann 810-3090-S Manual Del Propietário página 16

Clear an assembly area and get a friend to
help you put your smoker together. Lay card -
board down to protect smoker finish and
assembly area.
Step 1
Place the grill body assembly on its end
with the lid open. Make sure that another
person is holding the grill body assembly
steady. The opening to the smoke stack
and grease drainage tray hole should be
facing up as illustrated.
Step 2
With the grill body assembly standing on
its side as in Step 1, attach the right rear
leg (without axle holes) to the grill body
assembly. Align the bolts of leg with the
pre-drilled holes in the grill body assembly
as illustrated. Attach using four
M6 X12 mm bolts, M6 flat washers
and M6 nuts. Hand tighten only. Do not
attach the right front leg yet.
Step 3
Insert the bottom shelf (curved end
pointed down) into the mounted right rear
leg. Insert bottom shelf into right front leg.
Attach right front leg onto grill body
assembly using the same technique
described in Step 2.
15
Grease Hole
Grill Body
Assembly
Right Front Leg
(without Axle Holes)
Smoke Stack
Opening
Top View
Right Rear Leg
(without Axle Holes)
Bottom Shelf
Grill Body
Assembly
M6 X 12 mm
Bolts
M6 Flat Washers
M6 Nuts