Trouble Shooting - Brinkmann 810-3090-S Manual Del Propietário

TROUBLE SHOOTING

PROBLEM CAUSE
1. Check that the 3-wire plug is fully seated
Electric
element into a 3-wire grounded GFCI outlet wired
will not for 120 volts and protected at 7 or 10
amps.
heat up
2. Check the breakers or fuses for the outlet
being used are not open or shorted.
3. Check that the GFCI outlet has not been
tripped.
4. Electric element only heats up (becomes
red) during the first 4 minutes after power
switch is turned on.
1. Adjust temperature control on temperature
Grill is
controller.
not getting
hot enough
2. Avoid the temptation to check food too
often.
3. Verify that there are pellets in pellet hopper.
4. Fire goes out on "LOW" setting.
1. Adjust temperature control.
Grill is
getting
too hot
CORRECTION
1. Reseat plug in a 3-wire grounded GFCI
outlet wired for 120 volts and protected at
7 or 10 amps.
2. Reset breakers or replace fuse.
3. Reset GFCI outlet.
4.Turn Power switch "Off" then "ON" again.
1. Turn up heat on control dial.
2. Opening the door allows heat to escape
and slows the cooking process; open door
only when necessary.
3. Add pellets and allow sufficient time for the
pellets to travel from the pellet hopper to
the firepot (can take up to 7 minutes).
4. Excess ash. IMPORTANT: Remove all
unburned pellets and ash from inside and
around the firepot. A shop-vac is ideal for
the task CAUTION! ASSURE THAT THE
GRILL IS COLD TO AVOID A FIRE FROM
HOT ASH.
1. Turn down heat on temperature control
dial.
10