Other References - American Standard Advanced Clean 3.0 SpaLet Manual Del Usario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Other References

®
The SpaLet
Seat Temperature
is Adjusted to Set Levels.
The temperature of the SpaLet seat is maintained at
constant temperatures in accordance with the tem-
perature set with the switch.
Seat temp.
Off (room temperature) and Low (approx. 82.4ºF) to
High (approx. 96.8ºF)
Nozzle Spray in Winter.
The nozzle spray may weaken or take longer than
usual to discharge during winter or other times when
the water temperature is significantly low.
The Seat Sensor Prevents In-
correct Operation.
This SpaLet seat
is equipped with a
seat sensor to pre-
vent the spray from
spraying if switches
are pressed when
no one is sitting on
the SpaLet seat.
* The back cleansing, back cleansing - mild, front
cleansing, and dryer functions do not operate if no
one is sitting on the SpaLet seat.
* The seat sensor may not function correctly if covers
are installed to the SpaLet seat or seat lid.
* Back cleansing or similar functions may not operate
during a brownout while using the SpaLet seat. In
such cases, stand up from the SpaLet seat and wait
1 to 2 seconds before sitting back down.
Since the SpaLet seat is designed to move in the
vertical direction, there is a space between the
SpaLet seat cushion parts on the bottom side and the
top of the toilet bowl.
Seat sensor
switch is installed.
21 - EN
Seat sensor switch
(Built into the
seat unit)
SpaLet seat lowers
by approximately
5 mm when a
person sits on it.
The SpaLet Seat and Seat Lid
Close Slowly.
To reduce potential impact when the SpaLet seat and Seat
lid close unexpectedly, the SpaLet seat is
equipped with a slow close seat mecha-
nism to close the SpaLet seat and lid
slowly.
This slow close seat mechanism does
not function when the power is turned off.
* Note that closing the SpaLet seat and lid forcefully
may cause damage.
The SpaLet Seat is Equipped
with a Low Battery Indicator.
The battery LED on the remote
control flashes when the batter-
ies are low. Replace with new
batteries as soon as possible.
(+ Page 41)
* Pressing a remote control switch while the battery
LED is flashing sometimes causes signals not to
reach the toilet body, which results in no operation.
Bleed Air from the Water Pipes
Before Initial Use.
Make sure to bleed air from the water pipes before
using the SpaLet seat for the first time or after the wa-
ter had been drained to prevent freezing.
When siting on the SpaLet seat, water discharges
from a point near the nozzle tip for approx. 30 sec-
onds.
Release Air from the Water
Pipe before Using the Product
for the First Time.
Release air from the water pipe when using the product
for the first time after installation or when water has been
drained for freeze prevention.
When a person sits on the SpaLet seat, water will flow
out from the nozzle area for approximately 30 seconds.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido