American Standard Advanced Clean 3.0 SpaLet Manual Del Usario página 52

Troubleshooting
Other (Continued)
Symptom
● There is play
®
in the SpaLet
seat.
● One of the feet
on the back
side of the
SpaLet seat
is not making
contact with
the toilet bowl.
There is a gap
between the toilet
body and ceramic
portion.
Water is leaking
Desire to reset
all settings to the
default settings.
Using the SpaLet
seat causes the
room lighting to
flicker.
The nozzle shut-
ter does not
close.
The fan operating
sound can be
heard when the
product is not
used.
49 - EN
Cause
This is not a malfunction.
The construction of the SpaLet seat is different at the top and bottom
sections. For this reason, there are gaps between the SpaLet seat feet
and the toilet bowl.
This SpaLet seat is designed so that only one front foot makes contact
with the toilet bowl. Therefore, the SpaLet seat can continue to be used.
This is not a malfunction.
A gap may be visible due to the individual differences of fired ceramic prod-
ucts.
Please continue to use.
The strainer is loose.
There is debris on the strainer.
The temperature is too high.
Condensation is forming.
Reset all settings changed using
the procedures described in the
"Useful Functions" section to the
default settings.
This is not a malfunction.
This can happen due to the temporary increase in power consumed to
heat the water for the nozzle spray. Please continue to use.
This is not a malfunction.
The nozzle filter opens while the air shield deodorizer is operating. Turn
off settings as necessary.
The deodorizing fan operates for 1 minute after the user stands up from
the SpaLet seat.
Solution
Tighten the strainer.
Clean the strainer.
Frequently wipe the water drops.
Also make sure that there is suffi-
cient ventilation.
Perform the procedure to reset set-
tings to default settings.
Page
-
-
40
40
-
20
-
-
13