Turning The Camera On And Off; Taking Photos - LEXIBOOK DJ033 Serie Manual De Instrucciones

1. Press the Power button (9) for about 3 seconds to turn the camera on.
The LED will light up for a moment and the camera will sound a beep to
confirm that it is ready for use.
2. Press and hold the Power button (9) for about 3 seconds again to turn it off.
Note: The camera will auto power off after a few seconds of inactivity.
You are already in camera mode when you switch on the unit:
1. Press the Shutter button (1) to take a photo. The camera will beep twice
to confirm that a picture is taken.
2. To check the number of pictures you have left to take, the battery level
or resolution, press the Menu button (9) once in camera mode. Wait a
few seconds to automatically go back to the camera mode.
Note:
• When the camera's built-in memory is full, if you try to take a photo, the
LCD screen will display a warning message.
• When the SD card inserted in the camera is full, you will not be able to
take new photos. Make sure you transfer all your photos to your computer.
Switch on the camera:
1. In camera mode, press the Down/Flash button (10) until the
appears on the lower left corner of the LCD screen. The auto flash
function will be activated.
2. In camera mode, press the Down/Flash button (10) until the
appears on the lower left corner of the LCD screen. The flash function will
be activated.
3. In camera mode, press the Down/Flash button (10) until the
appears on the lower left corner of the LCD screen. The flash function will
be disabled.
18
DJ033seriesIM1210.indb 18

TURNING THE CAMERA ON AND OFF

Auto flash
Flash on
Flash on

TAKING PHOTOS

FLASH FUNCTION
icon
icon
icon
25/05/2010 6:31