Installing A Memory Card; Turning The Camera On And Off - LEXIBOOK DJ090 Serie Manual De Instrucciones

página de 130

/ 130
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

All manuals and user guides at all-guides.com

WARNING: Mal-function or loss of memory may be caused by strong frequency interference

or electrostatic discharge. Should any abnormal function occur, remove the batteries and

m of the

insert them again.

WARNING: Danger of explosion if battery is incorrectly replaced. Replace with same or

equivalent type recommended by the manufacturer. Discard used batteries according to the

manufacturer`s instructions or locals laws.

To store more pictures, you need to insert an SD card (not included) into your digital

camera so you can save your files.

the

To insert the memory card:

r replace

1. Turn off the camera.

2. Open the mini USB/SD card/battery compartment by pulling the latch down. Insert the

puter

3. Turn the camera on. The memory card icon "SD" should be visible on the LCD screen.

4. To remove the card, push it in slightly to release it from the slot.

Notes:

e camera

• Keep the SD card in "unlock" status before using.

• Always turn the camera off when you insert or remove an SD card.

• We recommend that you purchase a good quality SD card.

Press and hold the Power button (2) to turn the camera on. When you turn the camera

on, the red Power LED indicator (6) illuminates. You can hear a beep sound and the LCD

screen lights up to confirm the camera is ready for use.

Press the Power button (2) once more to turn the camera off. A beep will sound and the

screen will go blank.

Note: To save battery power, the camera will auto standby after a period of inactivity (30

seconds approximately). Press the Power button (2) to reactivate the camera. You can

change the auto power-off time by setting the function "Auto Power Off" (see the "Setup"

section).

DJ090series1213_23May_V06.indb 21