Velux KLI 110 Instrucciones página 17

1
2
PRG
max 2 sec
4
max 2 sec
32 VELUX
4
3
max
5 sec
ENGLISH: Removing/adding electrical products connected to con-
trol unit KLC 500 from/to control keypad KLI 110
Disconnect all electrical products and reconnect only products to be
1
removed/added to control keypad KLI 110.
2 Remove/add control and transmit functions by pressing PRG button
in keypad for max 2 seconds. This procedure can take up to 2 min-
utes. LED flashes green slowly.
Remove cover from control unit. When LED in keypad flashes green
3
quickly, press test button in control unit for max 5 seconds to receive
system in the control unit and to transmit function of control unit.
When the first electrical product runs briefly back and forth, config-
4
ure the product(s) in the keypad by pressing any operation key for
max 2 seconds. LED flashes green slowly for a few seconds.
The product can now be controlled by control keypad KLI 110.
When configuration has been completed, LED is green for 4 seconds.
If configuration has failed, LED is red for 4 seconds.
Note: For electrical products controlled by a remote control KLR 100,
please refer to the user manual for KLR 100.
ESPAÑOL: Eliminar/añadir productos eléctricos conectados a la
unidad de control KLC 500 en el teclado de control KLI 110
Desconecte todos los productos eléctricos y reconectar solo los pro-
1
ductos que desea eliminar o añadir al teclado de control KLI 110.
Elimine/añada control y transmita las funciones presionando el botón
2
PRG en el teclado durante un máximo de 2 segundos. Este proce-
dimiento puede llevar hasta 2 minutos. El LED emite una luz verde
lentamente.
Quite la cubierta de la unidad de control. Cuando el LED del teclado
3
de control emita una luz verde rápidamente, presione el botón de
prueba de la unidad de control durante un máximo de 5 segundos
para que esta reciba señal del sistema y para transmitir las funciones
de la unidad de control.
VELUX 33