EHEIM 1260 Manual De Instrucciones página 9

Uni_1260/62-3260/64_03.04
English
Thank you
for purchasing your new EHEIM pump that provides optimum per-
formance with maximum safety and reliability.
Safety instructions
All electrical equipment in the water must be disconnected from the
mains during care and maintenance work.
The connecting line of this device can not be replaced. When the line is
damaged, the device must no longer be used. Never carry the pump by
the cable; do not bend the cable.
The pumps may only be used in garden ponds and their area of protec-
tion if installed according to prevailing regulations. As a means of pro-
tection against overly high shock hazard voltage, the installation must
show a leakage current safety guard with a rated residual current of no
more than 30 mA. Please consult your electrician.
Notice: These divices produce magnetic fields which might caus elec-
!
tronic and mechanical disturbances or damages. This also refers to
pacemakers. Please consult the manuals of medical equipment for the
required safety margins. Attention: Maintenance work presents the risk
of crushing due to high magnetic forces.
The product is qualified in accordance with the respective national regu-
lations and guidelines and meets EC standards.
geprüfte
Sicherheit
Universal Pumps 1260010 and 1262010
- suitable for outdoor use -
Model: see type plate on pump housing
Function
A Motor body
pressure side carrying handle
pump cover with o-ring
ter intake grille
The pumps 1260010 and 1262010 - suitable for outdoor use -
are equipped with a 10 m cable according to regulations and
can be used submerged as well as outside the water. They are
not self-priming; when used outside the water they must be in-
stalled constantly below water level. The pump must not run
dry. Temperature range max. 35°C.
Installation
B The carrying handle should be inserted, from the front, into
the upper groove in the motor body. For pond use, the
handle serves to secure a retaining rope.
C If the pump is used under water, it must only be operated
using in the built-in prefilter. For this purpose, cover the in-
take grille aperture with the cap.
02.03.2004 11:13 Uhr
mounting plate threaded adaptor,
impeller assembly
retaining ring coarse fil-
threaded adaptor, intake side
Seite 9
cap.