Black 2-1/4" Flat Head Screw; Silver 1" Large Head Screw - Sauder 420196 Instrucciones De Montaje

Tabla de contenido

Publicidad

Step 17
1
102S

SILVER 1" LARGE HEAD SCREW

(2 used in this step)
Fasten the DRAWER FRONT MOLDING (R) to the
å
DRAWER FRONT (N). Use two SILVER 1" LARGE
HEAD SCREWS (102S).
3
U n
fi n
s u
r f a
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D716) into the
å
grooves in the DRAWER SIDES (D14 and D15) and
DRAWER FRONT (N).
www.sauder.com/services
N
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D716
i s h
e d
c e
D15
N
VIEW THE T-LOCK BOX VIDEO
2
R
Groove
Insert the DRAWER SIDES (D14 and D15) at an angle
å
into the slot at each end of the DRAWER FRONT (N).
4
D14
Fasten the DRAWER BACK (D78) to the DRAWER
å
SIDES (D14 and D15). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S). Repeat portions 2-4 of this step
for the small drawer using M, D24, D25, D109, and D716.
420196
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D14
D15
N
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
D78
D15
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 21

Publicidad

Tabla de contenido
loading

Tabla de contenido