Black 1-9/16" Flat Head Screw - Sauder 427287 Manual De Instrucciones

Step 37
1
D14
R
Groove
å
Insert the LARGE DRAWER SIDES (D14 and D15)
at an angle into the slot at each end of the LARGE
DRAWER FRONT (R).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER SIDES (D14 and D15).
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of the LARGE
DRAWER BACK (D78).
å
Repeat this step for the other LARGE DRAWER.
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D78
D14
D716
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D716) into the grooves in
the LARGE DRAWER SIDES (D14 and D15) and LARGE
DRAWER FRONT (R).
Start each screw a few turns before
completely tightening any of them.

BLACK 1-9/16" FLAT HEAD SCREW

D15
427287
With the palm of
your hand, tap
the DRAWER
U n fi
BOTTOM down
n i s h
s u r
into the groove.
e d
f a c
e
D716
D14
D15
R
30S
(8 used in this step)
9
Page 43