Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Electrical Connections (see figures 1 and 2).
a.
Remove the cover on the back of the driver housing with using a T20
Torx® tool.
b.
Strip 1/4" of insulation from the wiring leads.
c.
Attach the appropriate wires to the terminals on the back of the driver
housing. Connect the wire from the positive (+) lead on the amplifier to the driver
terminal that is painted red.
Do not connect wires when power is applied.
When connecting multiple speakers, polarity MUST be maintained. The
painted red terminal is positive (+).
3.
Power Adjustment (see figures 1 and 2).
Multiple power settings are achieved on the model AM100T by adjusting the
power setting switch located under the cover on the back of the driver housing. The
unit is factory set to the 100W position.
E.
SERVICE.
Any maintenance must be performed by a trained electrician in accordance
with NEC guidelines and local codes. Do not perform maintenance on this
device while the system power is on.
Federal Signal will service your equipment or provide technical assistance with
any problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be
accompanied by a Return Material Authorization. This R.M.A can be obtained from the
local Distributor or Manufacturer's Representative.
At this time a brief explanation of the service requested or the nature of the
malfunction, should be given.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
-3-
Publicidad
