Mafell ERIKA 60 Traducción Del Manual De Instrucciones Original página 36

Defect
Machine stops while cutting is in
process
Workpiece jams when feeding
Burn marks on the cut surfaces
Chip outlet blocked
Cause
Mains failure
Machine overloaded
Blunt saw blade
Stop rail of the universal stop is
not parallel to the saw blade
The saw blade used is unsuitable
for the task or blunt
Operation without extraction
Extraction too weak
Wood particles in the chip ejector
-36-
Elimination
Check mains back-up fuses
Reduce feed speed
Hold workpiece and turn motor off
immediately. Then exchange the
saw blade
Readjust the stop rail, see chapter
5.6
Replace saw blade
Remove chips while the machine is
switched off (see Fig. 8 - page 3).
The protective sliding cover 52
must be opened. To do so, detach
screw 51 with the Allen key 22. Pull
the locking recess 50 on the saw
guard downwards and pull the
protective sliding cover forward.
The chips in the chip duct can now
be easily removed downwards.
Afterwards close and engage the
protective sliding cover again.
Caution! Retighten screw 51.
Use an extraction unit, which
guarantees an air speed of at least
20 m/s (65.6 ft/sec.) at the
extraction connection piece
Remove chips while the machine is
switched off (see Fig. 8 - page 3).
The protective sliding cover 52
must be opened. To do so, detach
screw 51 with the Allen key 22. Pull
the locking recess 50 on the saw
guard downwards and pull the
protective sliding cover forward.
The chips in the chip duct can now
be easily removed downwards.
Afterwards close and engage the
protective sliding cover again.
Caution! Retighten screw 51.