Panel Adjustment - Sub-Zero IW-18 Manual Del Usario

PANEL INSTALLATION
Panel Installation
DRAWER PANELS (IW-30R)
Place the panel face down on a protected work surface.
Position the template flush with the top and sides of the
panel. Verify the correct side of the template is being used,
then mark and drill holes. Refer to the illustration below.
Use the T-20 torx drive provided, to partially insert a #8 x
screw into the second hole from the top on each side of the
panel. The screws should be approximately
of the panel and will support the weight of the panel during
installation.
Align the support screws on the back of the panel with the
slotted holes on both drawer mounting brackets. Refer to
the illustration below. Opening the drawer slightly may help
with alignment. Once the panel is supported by the screws,
partially insert a #8 x 1 / " screw into the second hole from
2
the bottom on each side of the panel, but do not tighten.
TOP OF DRAWER PANEL
TOP OF
DRAWER PANEL
TOP HOLES
FOR UPPER
AND LOWER
DRAWERS
Drawer panel template—top.
BOTTOM
HOLES FOR
LOWER
DRAWER
BOTTOM
HOLES FOR
UPPER
DRAWER
7021340
1
/
3 / " proud
(4)
16
BACK OF
DRAWER PANEL
Drawer panel mounting.

PANEL ADJUSTMENT

Close the door/drawers, now adjustments can be made to
align panels and reveals.
For side-to-side adjustment, move panels side to side, then
install and tighten all mounting screws.
"
2
For up-and-down and in-and-out adjustments, slightly
loosen the bracket screws. Depending on the level of
adjustment required, it may be helpful to loosen all of the
bracket screws which will allow for maximum adjustment.
Once the bracket screws are loosened, rotate the cams
to make adjustments. After adjustments have been made,
tighten all bracket screws. Refer to the illustrations below.
IN-AND-OUT
BRACKET
SCREWS
In-and-out adjustment.
BRACKET
SCREWS
CAM
UP-AND-DOWN
CAM
Up-and-down adjustment.
subzero.com
|
13