Depth Adjustment - Sub-Zero IW-18 Manual Del Usario

INSTALLATION
Alignment

DEPTH ADJUSTMENT

Adjust the depth of the unit to fit flush with surrounding
cabinetry. Follow these steps for a precision fit:
Place decorative panel on a protected work surface.
1
Place the panel thickness gauge next to the panel to
determine which notch corresponds with the panel thick-
ness. Refer to the illustration below. Once the proper
notch has been determined, mark that notch with a
marker.
With the door closed, position the top of the unit using
2
the panel thickness gauge. Refer to the illustration
below. Insert a #8 x 1 / " stainless steel screw above the
2
hinge, then insert a #8 x
handle side of the unit. For narrower units, the door may
need to be opened to access the handle side screw
location. Repeat the process to align the bottom.
PANEL THICKNESS
GAUGE
Panel thickness.
1 / " pan head screw on the
2
SCREW
SIDE TRIM
CABINETRY
FACE
FRAME
FRONT OF
UNIT
Unit depth.
ANCHORING
Once the top and bottom are aligned, verify the door/
drawers open properly, then install remaining screws in each
side trim.
|
subzero.com 9