Installation Of The Payload - Festo ELFA-RF-70 Instrucciones De Utilizacion

ELFA-RF
Mounting interfaces
on the end cover
e.g. with foot mounting HPE
1 (è Fig. 1)
on the threads
Tab. 1
• Push the lateral connection over the complete stroke path from one end position to the other.
The guide axis will then position itself free of distortion to the drive axis. If necessary, use a connec­
tion with tolerance compensation.
• Tighten the M5 screws with 5.9 Nm. For mounting accessories, comply with the tightening torque
specified in the associated product information, if available.
5.1.2

Installation of the payload

• Position the payload in such a way that the break-down torque
resulting from force F (parallel to the axis of motion) and lever
arm a remains low.
• Fasten the payload to the slide with screws and centring
sleeves. Take into account the maximum screw-in depth D
(è Tab. 2).
Size
Screw
Tightening torque
Max. screw-in depth D
Centring [H7]
Tab. 2
Festo – ELFA-RF – 1412NH English
on the profile
e.g. with slot nuts NST
in the slot 6
(è Fig. 1)
70
M5
[Nm] 5.9
[mm] 7.5
 9
[mm]
e.g. with profile mounting MUE
a
Fig. 4
Fig. 5
80
M5
5.9
9.5
F
M6
9.9
19