Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.5
STEEL PLINTH
(3)
b
()
(2)
(5)
(4)
b
(1)
1
a
Fig. 3 Plinth assembly
To assemble the plinth you will need:
•
Right and left side plinth (1 / Fig.3).
•
Plinth for the front and, for free-standing appliances, for the
rear also (2 / Fig.3).
Push the side plinth (1 / Fig.3) onto the legs from front to
rear using the fastener. The larger gap (b / Fig.3) on the
fastener must be at the bottom.
Affix the fasteners (3 / Fig.3) to the plinth (2 / Fig.3).
The larger gap (b / Fig.3) on the fastener must be at the
bottom.
Attach the plinth with the fasteners (3 / Fig.3) onto the feet.
1.6
WALL ASSEMBLY
(3a)
(2)
(3b)
(1)
(2)
(3c)
Fig.4 Wall assembly
The assembly kit for mounting the appliance to a wall contains:
2 fastening angles (1 / Fig.4), 4 screws with nuts, washers and
plugs (2 / Fig.4) to attach the appliance to the wall and
6 jackscrews with nuts (3 / Fig.4).
Assembling the fastening angles:
Mount the screws (2) into the wall, attach the two fastening
angles (1) and align them.
For each fastening angle (1), use two jackscrews (3a-c)
above and one below.
Jackscrews 3c:
•
use the left thread for the left fastening angle,
•
use the right thread for the right fastening angle.
Mounting the appliance:
Remove the base of the appliance.
Seite 16
INSTALLATION INSTRUCTIONS
(1)
(3)
(3c)
(2)
1
b
(4)
1
(3c)
1
Lift the appliance onto the spars (4) in the upper part of the
fastening angle.
Tighten the screws (3a) until the appliance is almost touch-
ing the wall.
Fine adjustments:
Use the jackscrews (3) to move the appliance into the cor-
rect position.
Fit the base of the appliance on again.
2.
ACCESS TO INTERIOR
C
A
2
D
1
5
1
Fig. 5 General view
2.1
FRONT PANELS (A) and (B)
(1)
Fig.6 Front panel
Unscrew screws (1 or 3). Also, in the case of a built-in oven,
unscrew screws (2 and/or 4) on the inside of the oven.
Pull the panel away forwards and downwards.
E
B
4
D
5
3 3
62.9582.01
Publicidad
Tabla de contenido
