Battery Charger Safety - Husqvarna 436 Li Manual Del Usuario

Ocultar thumbs Ver también para 436 Li:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Chain catcher
The chain catcher catches the saw chain if it breaks or
comes loose. If you have the correct chain tension, the
risk decreases. You also decrease the risk if you do the
correct maintenance on the guide bar and saw chain.
Assembly on page 13 and Maintenance on page
See
24 for instructions.
Right hand guard
The right hand guard works as a protection for your
hand if the saw chain breaks or comes loose. It also
prevents interference from branches and twigs when
you use the product.
Battery safety
WARNING: Read the warning instructions
that follow before you use the product.
Only use the Husqvarna BLi batteries that we
recommend for your product. The batteries are
software encrypted.
Use the Husqvarna BLi batteries that are
rechargable as a power supply for the related
Husqvarna products only. To prevent injury, do not
use the battery as a power supply for other devices.
Risk of electrical shock. Do not connect the battery
terminals to keys, screws or other metal. This can
cause a short circuit of the battery.
Do not use batteries that are non-rechargable.
Do not put objects into the air slots of the battery.
Keep the battery away from sunlight, heat or open
flame. The battery can blow up and cause burns
and/or chemical burns.
Keep the battery away from rain and wet conditions.
Keep the battery away from microwaves and high
pressure.
Do not try to disassemble or break the battery.
481 - 001 - 22.01.2018
Do not let battery acid touch your skin. Battery acid
causes injuries to the skin, corrosion and burns. If
you get battery acid in your eyes, do not rub but
flush with water for minimum 15 minutes. If battery
acid has touched your skin, you must clean the skin
with a large quantity of water and soap. Get medical
aid.
Use the battery in temperatures between -10 °C
(14 °F) and 40 °C (104 °F).
Do not clean the battery or the battery charger with
Maintenance on page 24 .
water. See
Do not use a defective or damaged battery.
Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
Keep the battery away from children.

Battery charger safety

WARNING: Read the warning instructions
that follow before you use the product.
Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
Use an approved grounded mains socket that is not
damaged.
Do not use other battery chargers than the one
supplied for your product. Only use Husqvarna QC
chargers when you charge Husqvarna replacement
batteries BLi.
Do not try to disassemble the battery charger.
Do not use a defective or damaged battery charger.
Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between doors, fences or similar.
Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
charger in an environment which has a good airflow,
dry and free from dust.
Do not put objects into the cooling slots of the
battery charger.
Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
Use approved wall sockets that are not damaged.
11

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

536 lixp

Tabla de contenido