To Use The Cutting Technique - Husqvarna 436 Li Manual Del Usuario

3. Cut branches that are in tension from the bottom up.
2
1
4. Cut branches piece by piece if necessary.
WARNING: Be careful when you remove
small branches and do not cut bushes or
many small branches at the same time.
Small and light branches can get trapped
by the saw chain and be thrown at you.
This can mean that you can not keep
control of the product, which can cause
serious injury.
5. Work on the left side of the trunk. Be as close as
possible to the product for maximum control. Let the
weight of the product be on the trunk if possible.
WARNING: Most kickback accidents
occur during limbing. Do not touch the
trunk, other limbs or objects with the
guide bar tip or the kickback zone. Be
careful with limbs that are in tension.
They can be thrown at you and cause
serious injury.
6. Keep the trunk between you and the product as you
move along the trunk.
18
3
4
2
1
3

To use the cutting technique

WARNING: Use full power when you cut and
decrease the speed to idle after each cut.
CAUTION: Motor damage can occur if the
motor runs for too long at full power without
load. For example if the motor runs for too
long without resistance from the saw chain
during cutting.
You can use the product to cut through wood in two
different positions.
• To cut on the pull stroke is when you cut with the
bottom of the guide bar. The saw chain pulls through
the tree when you cut. In this position you have
better control of the product and the position of the
kickback zone.
• To cut on the push stroke is when you cut with the
top of the guide bar. The saw chain pushes the
product in the direction of the operator.
WARNING: Be careful when you cut on
the push stroke. If the saw chain gets
trapped in the trunk, the product can be
pushed at you. You must prevent this
force or there is a risk that the kickback
zone of the guide bar touches the tree.
This will lead to a kickback.
481 - 001 - 22.01.2018