Symbols On The Product - Husqvarna 436 Li Manual Del Usuario

17. Spiked bumper
18. Bar tip sprocket
19. Saw chain
20. Guide bar
21. Chain catcher
22. Chain tensioning screw
23. Drive sprocket cover (536 LiXP)
24. Charging LED
25. Warning indicator
26. Power cord
27. Combination wrench
28. Battery charger
29. Button, battery status
30. Battery status
31. Warning indicator
32. Battery release button
33. Battery
34. Operator's manual

Symbols on the product

Risk of serious injury or death to the
operator or others. Be careful and use the
product correctly.
Read the operator's manual carefully and
understand the instructions before operation
of the product.
Wear approved protective helmet, hearing
and eye protection.
Use both hands when you operate the
product.
Never operate the product holding it with
one hand.
Never let the guide bar tip touch an object.
Warning! Kickback can occur when the
guide bar tip touches an object. This causes
the guide bar to be thrown in the direction of
the operator. Risk of serious injury or death.
Chain brake, engaged (right). Chain brake,
disengaged (left).
481 - 001 - 22.01.2018
Chain oil fill.
Direct current.
Recommended cutting equipment in this
example: Bar length 14 inches (356 mm),
max. nose radius 9 Teeth, chain type
Husqvarna H38.
Measured maximum kickback value without
XX
triggering the brake, for the bar and chain
combination on the label.
Measured maximum kickback value with
XX
brake for the bar and chain combination on
the label.
yyyywwxxxxx
Note: Other symbols/decals on the product refer to
certification requirements for certain markets.
Symbols on the battery and/or on the
battery charger
Fail-safe transformer.
Use and keep the battery charger indoors
only.
Double insulation.
The rating plate shows se-
rial number. yyyy is the
production year, ww is the
production week.
Recycle this product at a
recycling station for elec-
trical and electronic equip-
ment. (Applies to Europe
only)
3