Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
These Sanders are designed for sanding, feather edging and surface preparing.
For additional information refer to Safety Information Manual Form 04580387.
Manuals can be downloaded from www.irtools.com.
Product Specifications
Free Speed
rpm
Model
High
Low
3128
15000
12000
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16591778 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
1.
Regulator
2.
Emergency shut-off valve
3.
Hose diameter
4.
Thread size
Abrasive Installation
•
Disconnect the air supply before servicing or changing the sanding pads.
•
Backing Pads should be inspected for signs of irregularities such as fractures, excessive wear,
nicks, cuts, at the edges of center hole. Pads showing such characteristics should not be used.
Hook and Loop Sanding Paper Installation:
1.
Use wrench to hold spindle in place.
2.
Thread backing pad onto spindle.
3.
Center sanding paper and attach onto backing pad.
80181639_ed2
Pad Diameter
† Pressure (L
inch
mm
3
76.2
5.
Coupling
6.
Safety Air Fuse
7.
Grease - Remove sanding pad and inject
WARNING
Sound Level dB (A)
(ISO15744)
)
‡ Power (L
p
78.2
89.2
EN
Vibration Level
(ISO8662)
)
m/s²
w
< 2.5
EN-1
Publicidad
Tabla de contenido
