Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
These Air Orbital Sanders are designed to prepare metal and wood surfaces for painting and
finishing operations.
For additional information refer to Safety Information Manual Form 04580387.
Manuals can be downloaded from www.irtools.com.
Product Specifications
Free
Speed
Model
rpm
300G
10000
† K
= 3dB measurement uncertanity
pA
‡ K
= 3dB measurement uncertanity
wA
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16577215 and table on page 2. Maintenance frequency is shown in
circular arrow and defined as h=hours, d=days, and m=months. Items identified as:
1. Regulator
2. Emergency shut-off valve
3. Hose diameter
4. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
45735651_ed1
Pad Diameter
inch
mm
† Pressure (L
6
152
5. Coupling
6. Safety Air Fuse
7. Grease - Remove sanding pad and inject
Sound Level dB (A)
(ISO15744)
)
‡ Power (L
p
78.6
--
EN
Vibration Level
(ISO8662)
)
m/s²
w
4.7
EN-1
Publicidad
Tabla de contenido
