Product Safety Information; Product Specifications; Installation And Lubrication; Abrasive Installation - Ingersoll Rand 3103 Especificaciones Del Producto

Product Safety Information

Intended Use:
These tools are used for smoothening of welds and removal of rust and surface deposits.
For additional information refer to Rotary Air Sander, Polisher and Buffers Product Safety Information
Manual Form 04580387.
Manuals can be downloaded from www.irtools.com.

Product Specifications

Free
Speed
Model
rpm
3103 15,000
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16578577 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter

Abrasive Installation

• Disconnect the air supply before servicing or changing the sanding pads.
• Backing Pads should be inspected for signs of irregularities such as fractures, excessive wear,
nicks, cuts, at the edges of center hole. Pads showing such characteristics should not be used.
For Sanding Disk Installation:
1. Use wrench to hold spindle in place.
2. Thread backing pad onto the spindle.
3. Thread sanding disk onto the backing pad.
80181670_ed3
Pad Diameter
† Pressure (L
inch mm
2 50.8
3 76.2
6.
7.
8.
9.
WARNING
Sound Level dB (A)
(ISO 15744)
) ‡ Power (L
p
84.9 95.9
Thread size
Coupling
Safety Air Fuse
Oil
EN
Vibration Level
(ISO 8662)
)
m/s²
w
1.2
EN-1