Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
These Air Orbital Sanders are designed for smoothing and sanding paint, fiberglass, wood and
body filler.
For additional information refer to Product Safety Information Manual Form 04584967.
Manuals can be downloaded from ingersollrandproducts.com
Product Specifications
Free Speed
Model
rpm
312A
8000
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16575516 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator (not if lube-free tool)
4. Emergency shut-off valve
5. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
04581575_ed6
Pad Size
inch
mm
3.5 X 6-1/3
88 X 165
WARNING
6. Thread size
7. Coupling and anti-whip device
8. Safety Air Fuse
9. Oil (not if lube-free tool)
Sound Level dB (A)
(ISO15744)
† Pressure (L
) ‡ Power (L
p
86
97
* K = Vibration measurement uncertainty
EN
Vibration m/s²
(ISO28927)
)
Level
*K
w
7.7
1.9
EN-1
Publicidad
Tabla de contenido
