Preparation Before Washing - mabe LMD3123PBEB0 El Manual Del Propietario

install the water supply hose and select the water
level
On the models that apply insert the water supply hose into the water
inlet port on the control panel.make sure that the end of the coupling
hose is firmly inserted into the inlet port. Failure to do so will result in
leaks that could damage your washer".
To remove the water supply hose, just push the control handle as in-
dicated in the figure and pull it out.
Select water level according to the size of the load to be washed.
Never exceed the maximum filling level shown on the lint filters.
Set the water level adjusting lever to the proper line.
Important: The appliance must be connected to the water mains
using a new water supply hose. Do not use previous or old hose.

preparation before washing

1. Connect the water supply hose.
2. Make sure that the washing machine is properly grounded, then
insert the power plug into the outlet. Do not connect the ground
terminal to a gas or water pipe.
3. Lower the drain hose to the floor.
Important: An uneven or slanted floor may result in unstable work-
ing and abnormal noise. Make sure the machine stands firmly on an
even floor.
13