Steinberg RETROLOGUE2 Manual Del Usuario página 19

Retrologue
Synth Page
Retrigger
Sync Mode
Env3 Tab
The Env3 tab provides an additional third envelope that can be routed freely in the
modulation matrix. This envelope is bipolar, therefore, it is particularly suited to
modulate destinations like pan or pitch, for example.
The faders below the envelope display set the following parameters:
•
•
•
•
•
Defines whether the LFO is restarted with the specified start phase when a
new note is triggered. This parameter is available for the sync modes Off and
Tempo.
For monophonic LFOs, the parameter work as follows:
• Off – The LFO is not restarted.
• First Note – The LFO is restarted when a note is triggered and no other
note is held.
• Each Note – The LFO is restarted each time that a note is triggered.
For polyphonic LFOs, the parameter work as follows:
• Off – The LFO is not restarted.
• On – The LFO is restarted each time that a note is triggered. This way,
the polyphonic LFOs can modulate each voice separately.
Specifies how the LFO speed is set.
• Off – The speed of the LFO is set in Hz.
• Tempo – The speed of the LFO is set in note values. The resulting rate
depends on the tempo specified in the host sequencer.
• Beat – The speed of the LFO is set in note values. The resulting rate
depends on the tempo specified in the host sequencer. In addition, the
current start phase is calculated based on the current song position.
Select this option to synchronize the LFO restart to the transport of the
host application and align it to the beats of the project.
L0 sets the start level.
A sets the attack time.
L1 sets the attack level.
D sets the decay time.
S sets the sustain level.
19