Steinberg RETROLOGUE2 Manual Del Usuario página 21

Retrologue
Synth Page
Combining Modulation Source and Destination Using Drag and Drop
The most important modulation sources can be assigned to the most common
modulation destinations using drag and drop.
If a parameter can be used as modulation source, this is indicated by a drag icon .
You can drag the filter envelope, the amplifier envelope, the LFOs, the assignable
envelope Env3, and the wheel controls of the keyboard.
•
N
If all 16 modulation rows in the matrix are used, no further assignments can be
made. In this case, you cannot assign modulations using drag and drop.
Modulation Matrix Parameters
Modulation Sources
LFO 1/2
LFO 3/4
To create a modulation assignment, drag the drag icon over the parameter
that you want to modulate.
If a parameter can be used as modulation destination, this is indicated by a
green overlay that is displayed when you drag the modulation source on this
parameter.
If you drop the modulation source, the modulation is created and the
modulation matrix is updated accordingly.
OTE
The LFOs 1 and 2 produce cyclic modulation signals.
These LFOs are monophonic, that is, a single signal is used for all notes.
The LFOs 3 and 4 produce cyclic modulation signals.
These LFOs are polyphonic, that is, a new LFO signal is created with each
new note.
21