Schumacher Electric PI-70 Manual Del Usuario página 4

Ocultar thumbs Ver también para PI-70:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

This safety feature prevents damaging the inverter while testing
devices and equipment within the wattage range of the inverter.
iMPORTANT (Models Pi-120 and Pi-140): This inverter is designed
to power 100 watt devices or less when used with the vehicle 12
volt accessory port. The 100 watt limit is to accommodate the fuse
ratings for all vehicles. Some vehicles may allow the full output. If the
fuse blows when you switch on the device you are trying to use, you
have to either use a smaller device or you must purchase the 12 volt
accessory outlet to battery clips adapter (Schumacher Model SAC-103)
and connect the inverter directly to the battery.
iMPORTANT: This inverter uses a nonsinusoidal waveform. Therefore
we do not recommend you use it to power the following devices:
1.
Switch mode power supplies
2.
Linear power supplies
3.
Class 2 transformers
4.
Line filter capacitors
5.
Shaded pole motors
6.
Fan motors
7.
Microwave ovens
8.
Fluorescent and high intensity lamps (with a ballast)
9.
Transformerless battery chargers
Doing so may cause the device to run warmer or overheat.
4.
OPERATiNG iNSTRUCTiONS
(MOdELS Pi-70 ANd Pi-140)
1.
Push the 12-volt power plug firmly into the 12V accessory outlet.
2.
The LED indicator light should glow GREEN, verifying the
inverter is receiving power.
3.
Make sure the device to be operated is turned OFF.
4.
Plug the device into the inverter AC outlet or USB port.
5.
Turn the device on.
6.
To disconnect, reverse the above procedure.
• 4 •

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pi-120Pi-140

Tabla de contenido