Orbea RS Range Extender Manual De Usuario página 8

14 | OR B EA
10 C ONN ECTIN G TH E
RA NG E EXTE ND E R
Connect the Range Extender's connection cable to the
Range Extender's charging port and make sure it is prop-
erly attached to the Range Extender's charging port tab.
Open the Rise charging port cover and connect the other
end of the cable to the charging port.
Secure the connection cable to the bottle cage.
Cli Clic c k! k!
NOTICE
If Rise was turned on when you plugged the
Range Extender into the bike's charging port,
the electrical system will shut down and you
will need to turn Rise back on.
This happens because the system needs
to reboot to recognize the Range Extender
battery as part of the power supply. If you
were recording an activity through Garmin
Connect using the Orbea RS Toolbox app,
this will have no effect on the Rise data log
in Garmin Connect. Activity data will contin-
ue to be recorded when you start using Rise
again.
Once you start the bike with the Range Ex-
tender connected, the Range Extender is op-
erational. It is not necessary to turn on the
Range Extender.
USER' S MAN UAL R S RANGE EXTENDER
1 1 OP ER AT I N G TH E
R AN GE EXTE N DE R
The Range Extender powers the Shimano EP8 RS motor directly. When using Rise with
the Range Extender connected, only the Range Extender will supply current to the motor
until the Range Extender's charge is exhausted. After the Range Extender is depleted, the
internal battery will switch to supplying power to the motor if it has charge remaining.
Cli Clic c k! k!
1 2 C H A R G E L EV E L
DI S PLAY
12.1. DISPLAYING THE TOTAL CHARGE LEVEL OF THE
INTERNAL BATTERY AND THE RANGE EXTENDER
With the Range Extender connected to Rise (and Rise powered on after connecting the
Range Extender), the system will calculate the total capacity of both batteries (612 Wh),
and the information on the remaining charge of the system will show the total sum of
both batteries' charge levels.
EXAMPLE 1:
BATTERY
Internal RS battery (360 Wh)
Range Extender (252 Wh)
EXAMPLE 2:
BATTERY
Internal RS battery (360 Wh)
Range Extender (252 Wh)
- With Shimano EW-EN100 control unit
With the bike powered on, the Shimano EW-EN100 con-
trol unit will show the charge level of the battery(s) using
LED1. LED1 will illuminate green until the charge level is
below 21%, after which the LED1 will illuminate red. When
the battery is about to run out, LED1 will blink red.
Cli Clic c k! k!
SYSTEM CHARGE LEVEL
BATTERY CHARGE LEVEL
50% (180Wh)
50%
(306 Wh of 612 Wh)
50% (126 Wh)
SYSTEM CHARGE LEVEL
BATTERY CHARGE LEVEL
100% (360Wh)
79%
(486 Wh of 612 Wh)
50% (126 Wh)
LED 1
100% - 21%
20% or less
Almost
exhausted
ORBEA | 15
EN