Makita XCU03 Manual De Instrucciones página 60

TROUBLESHOOTING
ment parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
Cutting tool does not rotate:
stop the machine immediately!
Abnormal vibration:
stop the machine immediately!
Cutting tool and motor cannot stop:
Remove the battery immediately!
OPTIONAL
ACCESSORIES
WARNING:
Do not mount a metal blade on
this tool and only use the recommended accesso-
ries or attachments indicated in this manual.
use of a metal blade or any other accessory or attach-
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
accessories or attachments might present a risk of
for its stated purpose.
If you need any assistance for more details regard-
Center.
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
correctly.
cutting tool.
correctly.
One end of the nylon cord has been
broken.
correctly.
Electric or electronic malfunction.
20
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Ask your local authorized service center for repair.
it is rotating to cause the cord to feed.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.
NOTE:
differ from country to country.
MAKITA LIMITED WARRANTY
most current warranty terms applicable to this product.
warranty details set forth at below website for your
respective country.
Canada: www.makita.ca
Other countries: www.makita.com
ENGLISH
-