Sauder 423434 Manual De Instrucciones página 17

Step 13
Carefully stand your unit upright.
å
Push the DOOR STOP (4I) into the hole in the bottom of the SHELF (C).
å
Before fastening the DOOR to your unit, be sure the mounting screw
å
is against the stops as shown in the right diagram. If it isn't, loosen the
mounting screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the DOOR (J) to the RIGHT END (A) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten the PULL (149K) to the DOOR (J). Use two SILVER 5/8"
å
MACHINE SCREWS (15S).
See the next step for DOOR adjustments.
å
www.sauder.com/service
C
A
J
4I
423434
Stop
Mounting
screw
Hinge
SILVER 5/8" MACHINE SCREW
(2 used for the PULL)
149K
15S
Page 17