Maintenance - Mondolfo Ferro Startline S 524 Manual De Uso

Clamping plate not adjusted.
➥ Adjust the plate.
Pole not tilted
Faulty pole tilting cylinder.
➥ Replace the pole tilting cylinder.
No air supply to cylinder.
➥ Replace the cock.
Air leak from the valve.
➥ Replace valve or pole tilting cylinder.
The pole tilts violently or too slowly
Release valve incorrect setting.
➥ Adjust the discharge regulators.
Hare: speed increase.
Turtle: speed reduction.
Tyre pressure gauge needle fails to return to 0
Pressure gauge faulty or damaged.
➥ Replace the pressure gauge.
The lubricator does not work
No oil in lubricator.
➥ Top up lubricator with SAE20 non-detergent oil.
Lubricator broken.
➥ Replace the lubricator

12. MAINTENANCE

It is prohibited to perform any operation that changes the pre-set value of the pressure
regulation valve or pressure limiter. The manufacturer declines all liability for damage
resulting from tampering with such valves.
Before making any adjustments orcarrying out maintenance on the machine,
disconnect the electrical and compressed air supply and make sure that all moving
parts are locked in place.
Startline S 424-S 421-S 521-S 524 Operator manual
WARNING
WARNING
UK
147