Assembling Your Kickscooter; Installing A Second Battery Pack - Segway ninebot KickScooter ES Serie Manual De Usuario

4 Assembling Your KickScooter

1. Unfold the stem and push it until you hear a
click. Then unfold the kickstand to support
the scooter.
3. Install four screws (two on each side) with
the included hex wrench.
06
2. Firmly connect the wires inside the handle and
the stem. Slide the handle onto the stem. Be
aware of the correct orientation.
Head Light
toward front
4. Verify that your KickScooter powers on and off.

5 Installing a Second Battery Pack

Follow these steps when installing a second battery pack:
1. Remove the three screws on the stem, as shown.
Then remove the cover near the charge port.
3. Install the external battery on the rail and fix it with the M4 (20mm)
screws (2 pcs), provided with this product. After they are properly
installed, block the screw holes with the rubber stopper.
Warning: please use the screws provided with this product only.
2. Install the rail with the M4 (10mm) screws (3
pcs), provided with this product. Please make
sure it is properly fixed.
4. Verify that your KickScooter powers on and off.
07