Touch Screen; Menu Navigation; Virtual Keyboard - Hach ORBISPHERE K1200 Manual Básico Del Usuario

• Sensor measured values
• Measured sensor trends (for the last 10 minute to last hour)
• Measured sensor data alarm limits and other events
• Temperature

5.2 Touch screen

The user interface on the front panel is a touch screen providing easy selection through menus. All
the measurement, configuration, calibration and standard service routines can be called by pressing
buttons and menu bars on screen.
The display can be configured to only show a sensor measurement, or to show a parameterized
graphic representation of the last measurements.

5.3 Menu navigation

Pressing the "menu" button in the header bar calls the main menu. The
display is made of three columns:
• The left shows the menu options
• The center shows a tree view of the position inside the menu
structure
• The right has the following generic controls:
• Up - Return to previous menu (one step back)
• Main - Jump directly to main menu
• Close - Close the menu and go back to the measurement display.
• Help - Help topics concerning current menu

5.4 Virtual keyboard

When a value or text is to be edited a virtual keyboard will appear on screen and can be used like a
standard keyboard. Press CAP to access special keys. When input is complete press the Enter key
to confirm and exit the virtual keyboard. During editing, the edited field name is displayed along with
units where applicable.
Section 6 Start up
When the instrument is started for the first time, security is enabled. The user must enter a factory
configured login credentials (user ID and password) to get access to the instrument. Make sure to
change the default login credentials at startup. Refer to for additional information.
Do the steps that follow to change the default login credentials and add users and user access rights.
1. Push OK when the message to change the default login credentials shows on the display. Push
OK.
2. Push the padlock icon on the header bar of the top of the display for more than 2 seconds to
unlock the touch screen.
The login window shows on the display.
3. Enter the default user login credentials: "1007" for the ID and "1234" for the password. Push OK.
4. Push OK when the message to change the defautl loggin credentials shows on the display.
The users table, which is used to manage the registered users, shows on the display.
5. Push on the row of the default user. The user modifcation window shows.
6. Change the Name, ID, Password and security level values. Push OK to save the values.
7. Complete the table with the necessary users or push OK to leave.
Note: If the instrument security is enabled and the login credentials are not known, contact Hach Service support
with the recovery code to get the login credentials. The recovery code shows on the login window. The supplied
login credentials expire in one day. Make sure to change the login credential with known values.
14 English