Best CC34IQSB Manual Del Usuario página 12

3. From the room interior, pull down both
closure panels. Fig. 16.
4. Remove (4) screws from the electrical
compartment access panel. Slide the
panel sideways to expose the electrical
wiring box.
5. From the electrical box marked "120 VAC
Inlet" , remove (2) screws that secure the
cover to the metal wiring box. Fig. 17.
6. Pull 120VAC electrical power cable into
the box and secure with an appropriate
cable clamp.
7. Make electrical connections inside the
box. Connect white-to-white, black-to-
black and green-to-ground.
8. Replace the wiring box cover and the
screws. Make sure wires are not pinched
between the cover and box.
9. Replace the electrical compartments ac-
cess panel and (4) screws.
MAKE-UP AIR DAMPER
CAUTION: The hood is compatible only with Broan Make-Up Air Damper Model MD6T,
Model MD8T or Model MD10T (optional). Purchase separately.
Make the connection to the Make-Up Air Damper with low voltage wiring, as shown. See
Make-Up Air Damper instructions for additional information. (Fig. 18)
MAKE-UP AIR DAMPER
GRD
MAKE UP DAMPER CONNECTION
20 GAUGE BELL WIRE FOR LOW
VOLTAGE CONNECTION ON
TOP OF HOOD
24V
TRANSFORMER
(INCLUDED)
120 VAC
60 HZ
- 12 -
CONNECT WHITE-TO-WHITE,
BLACK-TO-BLACK, GREEN-TO-GROUND
BOX MARKED
"120VAC INPUT"
(switched low voltage)
HOOD
FIG. 16
120 VAC
LINE IN
FIG. 17
WIRE BOX
FOR LOW
VOLTAGE
CONNECTION
FIG. 18