SUHNER LWE 10 DH Documentación Técnica página 4

15 Exhaust Hose
16 Muffler
17 Air Hose
Recommended Accessories
18 Coupling with min ID 7 mm/ 9/32"
19 1/2" -Service Unit ( Capacity 5-8 Micron). with wet air
include Lubricator
Suitable Tools
20 Reinforced Grinding and Cutting wheels , Flap discs
and Diamond discs 41/2"
21 4 1/2" Backing pads-22- with fiber discs, flange nut-23-,
Velcro pads and discs
24 Wire cup brushes etc.
Additional Abrasives and Tools
Can be found in the the
Wheel guard
In order to operate reinforced grinding and cutting wheels,
the wheel guard must be installed.
Wheel guard assembly and adjustment:
Mount wheel guard 4 to the angle head 1, depress positio-
ning lever 3 and adjust to required position. Before opera-
ting the tool, observe that position lever is back in locking
position.
Air supply requirements
The ISO/DIS quality specifications require, that air is free
of solid particles larger than 5 micron, remaining water
content to be max. 6 g/m3 (pressure dew point +3 degree
C) and air may contain 5 mg/m3 of oil. Therefore please
observe the following:
• Operating with dirty and unlubricated air reduces tool
life substantially.
Before installing extension hoses, blow them clean and
minimize , if at all necessary coupling and keep them
clean.
• Conserve
Put some drops of oil in the air inlet and briefly blow
through.
Safety Instructions:
• Do not exceed max. operating speed of tool and clam-
ping element.
• Observe accurate mounting of tools.
• Secure work, use clamps or a vise to hold work.• The
grinder operator shall wear safety goggles or face
shield at all times when the grinder is in operation.
• If noise level exceeds 85 dB(A) at the work station,
operator must use ear protection (plugs and/or ear
mufflers).
For additional safety instructions refer to enclosed bro-
chure DL 39 220 01
4
catalogs.
Operation conditions and instructions
The machine can be turned on and off by turning the lever.
1. Turn locking lever in direction indicated by arrow , and 2.
Depress valve lever 13.
Grinding/Deburring/Cleaning
• Never use a cut-off wheel for grinding/snagging.
• Observe even material removal, avoid chattering.
• Do not treat any material containing asbestos.
Change of tools/abrasives
• Lock spindle 2 with Lock button 8. Attention: only use
lock button, when machine is at a complete stop.
• Remove or mount flange nut 6+/or 22 using 2-Pin
Wrench. Clean mounting set before installation.
Attention: Tight sitting tools have to removed with open
end wrench , rather then with lock button operation.
• Check concentricity, use only vibration free tools and
always observe M.O.S. (Max. operating speed).
Maintenance
• Store tool in a clean, dry place.
Check the idling speed from time to time.
• Even if the tool still gives satisfactory service, have it
checked by a trained mechanic after 300 to 400 opera-
tion hours, or at least once a year. Disassembly motor,
clean and replace if necessary the four vanes.
Also check/replace grease -Molykote BR 2 plus- in the
gear head 9 (don't clean it).
• Warranty claims can only be considered, if tool is retur-
ned complete.
Accessories
All accessories can be found in the
Power Tool catalog.
Subject to change!
Abrasive