Lenco KCR-200 Manual De Usuario página 11

Displaying DAB+ Station Information
There are several types of information as listed below. To change the display information, press the INFO / MENU button (the INFO
button on the remote control) repeatedly.
1. Radio Text scrolling
Shows music titles or program details provided by the broadcaster
2. Signal Bar
Transmission signal level. The more the rectangles are filled, the stronger the signal is received. The unfilled rectangle is the
threshold level where the signal strength received should exceed this threshold. To improve the reception, adjust the antenna
position.
3. Program Type (PTY)
Type of program provided by the broadcaster
4. Multiplex Name
Displays name of multiplex to which the current station belongs
5. Frequency
Current channel number and frequency
6. Signal Error Rate
Shows the error rate. The larger this value, the more errors it receives. To improve the reception, adjust the antenna position.
7. Audio Bit Rate
This is the current channel audio Bitrate
8. Time
Displays the current time provided by the radio station
9. Date
Displays the current date provided by the radio station
OTHER DAB+ MENU OPERATIONS
Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu control.
Then press the or
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy environment. The DRC level of a broadcast is set by the
broadcaster and transmitted with the service. Changing the DRC value on your unit enables you to apply a scaling factor to this level.
There are three levels of compression:
DRC high:
DRC low:
DRC off:
1. Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu control.
2. Press the or
button.
3. Press the or
confirm.
4. Press the INFO / MENU button on the unit (the MENU button on the remote control) to exit the menu control.
Note:
Not all DAB+ broadcasts are able to use DRC function. If the broadcast does not support DRC then the DRC setting in the unit will
-
have no effect.
After you have adjusted the DRC level the sound may be louder.
-
Prune
This function removes inactive stations.
1. Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu control.
2. Press the or
button.
3. Press the or button (the
prune the unit.
4. Press the INFO / MENU button on the unit (the MENU button on the remote control) to exit the menu control.
button (the or button on the remote control) for different options as described below.
Maximum compression as sent with the transmitted service
Set to 1/2 that of the sent transmitted service
No compression
button (the or button on the remote control) until "DRC" is displayed and then press the ENTER
button (the or button on the remote control) to select the DRC value and then press the ENTER to
button (the or button on the remote control) until "Prune" is displayed and then press the ENTER
or button on the remote control) to select "<Yes>" and then press the ENTER button to
11