MBM CPG77T Manual De Uso E Instalación página 31

Every technical change has an
effect on the operation or safety
of the appliance and must there-
fore be performed by technical person-
nel of the manufacturer or by techni-
cians who are formally authorised by
the same. Failure to do so exempts the
manufacturer from any liability for for
any possible resulting modifications or
damage.
Upon arrival, check the integrity of
the appliance and its components
(e.g. power cord), prior to use. In
the presence of faults do not start the
appliance and contact the nearest servi-
ce centre.
Read the instructions before
acting.
be performed. As far as personal pro-
tective equipment is concerned, the Eu-
ropean Community has issued Direc-
tives which the operators must comply
with. Noise ≤ 70 dB.
It is forbidden the installation of
stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
Before making the connections
check the technical data shown
on the rating plate of the applian-
ce and the technical data in this manual.
It is strictly forbidden to tamper with
or remove the plates and pictograms
applied to the equipment.
Disconnect all supplies, if present
(e.g. water - gas - electrical) up-
stream the appliance whenever
you need to work in safe conditions.
Connect the appliance if present,
in the sequence of the water,
then to the gas network. Ensure there
are no leaks then proceed with the con-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear protective
equipment suitable
for the operations to
- 5 -
nections to the mains.
The appliance is not designed to
work in an explosive atmosphere
and as such its installation and
use is categorically prohibited in such
environments.
Position the entire structure, re-
specting the installation dimen-
sions and characteristics indica-
ted in the specific chapters of this
manual.
The appliance is not intended for
recessed installation. / The ap-
pliance must be used in a well
ventilated area. / The appliance must
have free drainage (not hindered or im-
peded by foreign bodies).
The gas equipment must be in-
stalled beneath an extraction
hood whose system must have
specifications in compliance with the
current regulations in the country of use.
Once the appliance is connected
to the power and drain sources, it
must remain static (fixed) in the
place of use and maintenance. Incorrect
connection may cause danger.
Use where appropriate flexible
cable for connection to the mains
electricity supply with characteri-
stics not inferior to the type model
H07RN-F. The supply voltage suppor-
ted by the cable with the appliance wor-
king must not differ from the nominal
voltage value ± 15% shown at the bot-
tom of the technical data table.
The appliance must be included
in an "Equipotential" ground dis-
charge system.
Drainage of the appliance must
be conveyed into the grey water
discharge network in an open
"glass" unsiphoned formation.
2.
EN